080-23104229

Pumps

All In One Whole House Booster Unit

A cold water booster set with integrated pump, 200 ltr storage tank and pressure manager PM2 controller.

Boost mains water supply, to satisfy the demand requirements of a combi boiler, unvented hot water cylinder, and any outlets that require a minimum operating pressure.


  • Fully packaged unit - including tank..
  • WRAS approved..
  • Nominal outlet pressure = 3bar @ 0.5 l/s.
  • Adjustable settings via pressure manager PM2 controller.
  • In built dry running protection.
  • For properties with 4 to 5 occupants, or where the storage tank refills very slowly, an additional 180 litre water storage unit is avail- able.


Boosts Pressure To One Or Two Outlets

This is a small stainless steel booster pump operated by an integral flow switch requiring a minimum flow of 2 l/m(1 pint in 15 sec).The pump add typically 0.5 bar to the upcoming pressure at a flow of 0.2 l/m.


  • Easy to install.
  • Automatic or manual operation.
  • Suitable for water temperature upto 70deg
  • Maintainence Free
  • Low noise level

Boosts Pressure Multiple Outlets

This is a cold water booster pump with integral controls.the pump maintains a system positively pressurised and can be used to boosts to outlets upto 13m above the level of pump.


  • Complete system - no additional control required.
  • Easy to install. Maintanence free.
  • Compact design
  • Built in dry running protection


All In One Whole House Booster Unit

The pumps are all non-self-priming, single-stage, centrifugal volute pumps with axial suction port, radial discharge port and horizontal shaft


  • Optimised hydraulics in housing and impeller = unimpeded liquid flow
  • O-ring seal between pump housing and cover = no risk of leakage
  • Housing, impeller and wear ring in different materials = improved corrosion resistance, no sticking elements


All In One Whole House Booster Unit

The pumps are all non-self-priming, single-stage, centrifugal volute pumps with axial suction port, radial discharge port and horizontal shaft.


  • Optimised hydraulics in housing and impeller = unimpeded liquid flow
  • O-ring seal between pump housing and cover = no risk of leakage
  • Housing, impeller and wear ring in different materials = improved corrosion resistance, no sticking elements